Tron Kit is a line following vehicle kit suitable for intermediate solderers. You'll also need to have access to some tools (as listed below).

NB. Battery is not included.

Hackable with Flow LT Hex Loading software & Flow USB Programmer.

Programming Options are Pre-program, Instant-Program, or HEX-Program.

Tools Required

1. Soldering Iron
   
2. Solder
   
3. Angled Side Cutters
4. Pliers and Xacto/Craft Knife or Dremel
5. Measuring Ruler or Venier Calipers

Instruction Manual - Free A4 pdf

Laminated Lights A3 page1 - page 2

See Additional Images to download (above)

Lesson/Unit Plan Ideas - Tron Kit

Construction & Electronics

·         Cutting Small Plastic Components with a Dremel Tool

·         LED (Light Emitting Diodes) with a Current Limiting Resistor

·         Infrared (IR) Reflection

·         Motor Control – 2 Channel Direction and Speed with the L293D

ASM Programming - Advanced

·         Digital Outputs (10)

·         TriState Multiplexing LED Control (High, Low, Off)

·         3x ADC Inputs

·         Word based Arithmetic on an 8bit PIC

·         Calibration through MIN/MAX Sampling

·         Standardised Sampling with Data Offset & Scale Equations

·         Calculating Gradients

·         Speed Control with 2x Hardware PWM (Pulse Width Modulation)

·         Motor Direction with the L293D Motor Driver IC

NB: Project requires one CR123A Battery (Not included).

** Un-programmed PICs require the use of our Flow USB Programmer to program the supplied microcontroller device.